Removal & Installation (Millenia)
- To prevent master cylinder overflow when caliper piston is depressed, remove and discard some brake fluid from master cylinder reservoir. Raise and support rear of vehicle.
- Remove rear wheel assemblies. Remove lower guide bolt from caliper. See Figure . Rotate caliper upward and support using wire. Remove "V" spring. Remove pads, shims and guide plates. Replace pads if lining thickness is less than .08" (2.0 mm).
- To install, reverse removal procedure. Use Disc Brake Expander (49-0221-600C) and an old pad to push piston fully inward to install disc pads.