LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1997 >> 626 ES, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.5L V6 >> Removal & Installation >> Cooling System Bleeding

Cooling System Bleeding

  1. Fill radiator and coolant reservoir. Start engine and allow to idle until engine is at normal operating temperature. Accelerate engine to 2200-2800 RPM for 5 minutes. Shut engine off and allow engine to cool.
  2. Repeat step 1). Remove filler cap. Verify coolant level is near filler neck. If coolant level is not near filler neck, repeat steps 1) and 2). Fill coolant reservoir to the FULL level.
scientia non olet · About LEMON Manuals