LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1997 >> 626 ES, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.5L V6 >> Removal & Installation >> Hydraulic Lash Adjuster >> Inspection

Hydraulic Lash Adjuster: Inspection

  1. Inspect components for damage. Measure HLA diameter and bore diameter, and determine oil clearance. Ensure oil clearance is within specification. Replace components if oil clearance is not within specification. See HYDRAULIC LASH ADJUSTERS  under ENGINE SPECIFICATIONS.
  2. Hold HLA upright and attempt to compress adjuster using hand pressure only. If plunger moves, replace HLA.
CAUTION: HLAs must be installed in original position or rapid camshaft wear will occur. Install NEW HLA if original position cannot be identified.
scientia non olet · About LEMON Manuals