MX-6 & 626
- Released pedal height is measured from carpet surface, on vertical portion of firewall, to pedal pad center. Disconnect stoplight switch electrical connector. Loosen lock nut on stoplight switch. Rotate switch away from pedal. Loosen push rod lock nut. Rotate push rod until correct pedal height is as specified. See BRAKE PEDAL HEIGHT SPECIFICATIONS table.
- Adjust pedal free play. See BRAKE PEDAL FREE PLAY. Tighten push rod lock nut to 18-25 ft. lbs. (24-34 N.m). Rotate stoplight switch until it contacts pedal, then rotate an additional 1/2 turn. Tighten stoplight switch lock nut. Reconnect stoplight switch electrical connector.
- Applied pedal height is measured from angled portion of firewall (without carpet) to pedal pad center. Start engine. Depress brake pedal with a pressure of 132 lbs. (60 kg). Measure applied pedal height. See BRAKE PEDAL HEIGHT SPECIFICATIONS table. If distance is not as specified, check for air in system, faulty rear brake adjustment, or worn shoes or pads. Repair as necessary.
BRAKE PEDAL HEIGHT SPECIFICATIONS
| Application | In. (mm) | ||
|---|---|---|---|
| Pedal Released - MX-6 & 626 | 7.5-7.7 (191-196) | ||
| Pedal Applied (1) - MX-6 & 626 | 3.3 (85) | ||
|
|||
NOTE:
When adjusting brake pedal height, a NEW stoplight switch must be used. Stoplight switch can only be adjusted one time.