Wheel Bearing: Removal
WARNING: This page is about a different car, the 1994 Mazda MX-3. However, it is still accessible from the selected car via links, so may be relevant.
- Raise vehicle, and support using safety stands. Remove wheel assembly. Remove grease cap and lock nut. On models with disc brakes, disconnect brake line from strut assembly (as necessary). On all models, disconnect parking brake cable from rear brake assembly.
- Remove caliper assembly, and wire aside. Disconnect ABS speed sensor (if equipped). Remove brake drum or rotor. Remove ABS speed sensor rotor from hub (if equipped). Wheel bearing is an integral component of hub assembly. Replace hub assembly as necessary.