LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> Protege DX, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL SOHC >> Removal & Installation >> Hydraulic Lash Adjuster (HLA) >> Removal

Hydraulic Lash Adjuster (HLA): Removal

  1. Disconnect negative battery cable. Remove cylinder head cover. Loosen rocker arm shaft bolts evenly in 2-3 steps, in reverse order of tightening sequence. See Figure.
    CAUTION: If HLA is difficult to remove from rocker arm, pliers may be used; however HLA or "O" ring may be damaged during removal and require replacement.
  2. Mark all parts for reassembly reference. Remove rocker arm shaft assembly from cylinder head. Disassemble rocker arm shaft assembly. Pull HLA from rocker arm.
scientia non olet · About LEMON Manuals