LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> Protege DX, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL SOHC >> Removal & Installation >> Camshaft >> Removal

Removal & Installation: Camshaft: Removal

  1. Disconnect negative battery cable. Drain coolant. Remove cylinder head. See CYLINDER HEAD. Remove rocker arm shaft assembly by loosening rocker arm shaft bolts evenly in 2-3 steps, in reverse order of tightening sequence. See Figure.
  2. Match mark each component for installation reference. Rocker arms are NOT interchangeable. Remove camshaft sprocket and distributor. Remove camshaft thrust plate, and slide camshaft out of head. Remove end seal from head.
scientia non olet · About LEMON Manuals