Sun Roof Does Not Tilt Or Slide
- Check 15-amp sun roof fuse located in fuse block, near left kick panel. If fuse is blown, replace fuse (repair wiring if necessary). If fuse is okay, turn ignition on. Measure voltage at Green/Orange wire terminal of sun roof switch 2-pin connector.
- If battery voltage is not present, repair Green/Orange wire between fuse and sun roof switch. If battery voltage is present, measure voltage at Green wire terminal of sun roof relay connector. If battery voltage is not present, repair Green wire between sun roof switch and sun roof relay.
- If battery voltage is present, disconnect sun roof relay connector. Check continuity between ground and Black wire terminal of sun roof relay connector. If continuity does not exist, repair Black wire between sun roof relay and ground. If continuity exists, check sun roof relay. See SUN ROOF RELAY TEST under COMPONENT TESTING.
- If sun roof relay is okay, disconnect sun roof motor connector. Check continuity of Blue, Yellow, Yellow/Red and Yellow/Green wire terminals between sun roof relay connector and sun roof motor connector. If continuity does not exist, repair wiring between sun roof relay and sun roof motor. If continuity exists, check sun roof motor. See SUN ROOF MOTOR TEST under COMPONENT TESTING.
- If sun roof motor is okay, disconnect sun roof switch connectors. Check continuity of Blue, Blue/White, Blue/Green, Blue/Yellow and Black wire terminals between sun roof switch connectors and sun roof motor connector. If continuity does not exist, repair wiring between sun roof switch and sun roof motor. If continuity exists, check sun roof switch. See SUN ROOF SWITCH TEST under COMPONENT TESTING.