LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> MX-5 Miata Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Removal & Installation - A/T) >> Automatic >> NAVAJO >> Removal

Section 72 (Removal & Installation - A/T): Automatic: NAVAJO: Removal

WARNING: This page is about a different car, the 1992 Mazda Navajo and 1992 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Raise and support vehicle. Drain transmission fluid. Remove starter. Remove torque converter bolts. Mark drive shaft for reassembly reference, and remove drive shaft. Install plug in rear of transmission to prevent fluid leakage.
  2. Disconnect speedometer cable, shift rod and kickdown cable from transmission. Depress tab on cable downshift retainer, and remove cable from bracket. Disconnect electrical connectors, vacuum hose and oil cooler lines.
  3. Support transmission using jack. Remove crossmember. Lower transmission slightly. Using another jack, slightly raise front of engine to access upper engine-to-transmission bolts, but DO NOT remove bolts yet.
  4. Remove lower converter housing-to-engine bolts. Remove dipstick tube. Remove upper converter housing-to-engine bolts. Slowly lower transmission.
scientia non olet · About LEMON Manuals