LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> MX-5 Miata Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Removal & Installation - A/T) >> Automatic >> B2200 & B2600i >> Removal

B2200 & B2600i: Removal

WARNING: This page is about a different car, the 1992 Mazda Navajo and 1992 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. On 4WD models, remove selector knob, console box, insulator plate, shift boot and transfer case shift lever. On all models, raise and support vehicle. Drain transmission fluid.
  2. Remove undercover (if equipped). Mark front (if equipped) and rear drive shafts for reassembly reference, and remove drive shaft(s). Install plug in rear of transmission to prevent fluid leakage. Disconnect speedometer cable, shift cable and vacuum hose from transmission.
  3. Remove crossmembers or front transmission supports from converter housing. Remove torque converter bolts. Disconnect kickdown solenoid and oil cooler lines from transmission. Remove starter. Disconnect remaining wiring connectors from transmission.
  4. Support transmission using jack. Remove rear transmission crossmember and transmission-to-engine bolts. Lower transmission from vehicle.
scientia non olet · About LEMON Manuals