Protege & 323 Removal & Installation: Installation
WARNING: This page is about a different car, the 1991 Mazda Navajo, 1991 Mazda MX-5 Miata, and 1991 Mazda 929. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Torque converter is correctly seated when distance between engine mating surface of converter housing and converter drive lug is .54" (14 mm).
- Tighten bolts to specification. See TORQUE SPECIFICATIONS TABLE at end of article. Install new clips on axle ends before installing axle shafts. Fill transaxle with required amount of ATF.