LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> MX-5 Miata Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Removal & Installation - A/T) >> B2200 & B2600i REMOVAL & INSTALLATION >> Removal

B2200 & B2600i REMOVAL & INSTALLATION: Removal

WARNING: This page is about a different car, the 1991 Mazda Navajo, 1991 Mazda MX-5 Miata, and 1991 Mazda 929. However, it is still accessible from the selected car via links, so may be relevant.
  1. On 4WD models, remove selector knob, console box, insulator plate, shift boot and transfer case shift lever. On all models, raise and support vehicle. Drain transmission fluid.
  2. Remove undercover (if equipped). Remove front and rear drive shafts (if equipped). Insert plug in rear of transmission to prevent fluid leakage. Disconnect speedometer cable, shift cable and vacuum hose from transmission.
  3. Remove crossmembers or front transmission supports from converter housing. Remove flexplate-to-converter bolts. Disconnect kickdown solenoid and cooler lines from transmission. Remove starter. Disconnect remaining wiring connectors from transmission.
  4. Support transmission using jack. Remove rear transmission crossmember and transmission-to-engine bolts. Lower transmission from vehicle.
scientia non olet · About LEMON Manuals