B2200, B2600i 2WD, Miata & MPV 2.6L

WARNING: This page is about a different car, the 1992 Mazda Navajo. However, it is still accessible from the selected car via links, so may be relevant.

Remove overdrive band servo cover and gasket. See Fig 1 . Loosen overdrive adjustment screw lock nut while holding piston stem stationary. Tighten piston stem to 61-87 INCH lbs. (7-10 N.m).
Back off piston stem 2 turns. While holding stem in this position, tighten lock nut to 11-30 ft. lbs. (15-40 N.m). Install overdrive band servo cover with NEW gasket. Tighten cover bolts to 44-62 INCH lbs. (5-7 N.m).

Fig 1: Adjusting Overdrive Band (B2200, B2600i 2WD, Miata & MPV 2.6L)

Courtesy of MAZDA MOTORS CORP.

NOTE: Navajo overdrive band adjustment procedure can also be used for intermediate band adjustment. See Figure .