LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> MX-5 Miata Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Servicing - A/T) >> Adjustments >> Neutral Safety Switch >> Except Navajo

Except Navajo

WARNING: This page is about a different car, the 1992 Mazda Navajo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place gearshift lever in "N" position. Ensure gearshift linkage is adjusted correctly. See GEARSHIFT LINKAGE  under ADJUSTMENTS. Loosen neutral safety switch mounting bolts at transmission. Remove screw from alignment pin hole at bottom of switch (if equipped).
  2. On B2600i 4WD, MPV 3.0L and 929, rotate switch and insert a 5/32"(4.0 mm) alignment pin (or drill bit) through alignment holes. On all other models, insert a 5/64" (2.0 mm) alignment pin (or drill bit) through alignment holes.
  3. On all models, tighten mounting bolts to specification. See TORQUE SPECIFICATIONS  table. Remove alignment pin. Install alignment pin hole screw (if equipped), and check switch operation. Vehicle should start only with gearshift in "P" or "N" position.
scientia non olet · About LEMON Manuals