B2200, B2600I 2WD, MIATA, MPV 2.6L, RX7 & 929
WARNING: This page is about a different car, the 1991 Mazda Navajo. However, it is still accessible from the selected car via links, so may be relevant.
- If vacuum diaphragm (modulator) is replaced, vacuum diaphragm rod length (depth) must be checked for new rod length. Proper length rod should be installed after measurement.
- Unscrew vacuum diaphragm from case. Remove diaphragm, diaphragm rod and rubber "O" ring. Measure dimension "N" using Adjusting Gauge (49-G032-355). See Fig 1. Use VACUUM DIAPHRAGM ROD SELECTION TABLE to select proper length rod.
VACUUM DIAPHRAGM ROD SELECTION
| Dimension "N" In. (mm) | Rod Length In. (mm) |
|---|---|
| 1.0099 (25.65) Or Less | 1.14 (29.0) |
| 1.0099-1.0197 (25.65-25.90) | 1.16 (29.5) |
| 1.0197-1.0394 (25.90-26.40) | 1.17 (29.7) |
| 1.0394-1.0492 (26.40-26.65) | 1.18 (30.0) |
| 1.0492-1.0689 (26.65-27.15) | 1.20 (30.5) |
| 1.0689 (27.15) Or More | 1.22 (31.0) |