LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> MX-5 Miata Base, Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Diagnosis - N4A-El/Hl & NC4A-El >> Self-Diagnosis (1994 MIATA Only) >> Retrieving Fault Codes >> HOLD Indicator Light Procedure

HOLD Indicator Light Procedure

  1. Locate Data Link Connector (DLC) underhood on left fenderwell. Short together GND and TAT terminals of DLC and turn ignition on. See Fig 1 . Warning codes are flashed on HOLD indicator light on dash. Codes are flashed in numerical order if more than one code is present.
  2. Note fault code numbers. See FAULT CODE table. Perform appropriate diagnostic code chart. See appropriate CODE CHARTS  . After repairs are made, clear codes.
Fig 1: Locating DLC GND & TAT Terminals
G95D20563Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals