LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> MX-5 Miata Base, Automatic >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Wheel Bearing >> Removal

Wheel Bearing: Removal

  1. Raise and support vehicle. Remove rear wheel assembly. Remove drive axle lock nut. Remove brake caliper assembly and wire aside. Remove screws and rotor. Disconnect ABS speed sensor. Remove knuckle assembly from upper and lower arms.
  2. Using Handle (49-G030-102), Installer (49-G030-727) and Puller (49-F026-103), remove hub from knuckle. Remove snap ring from knuckle. Using handle, installer and Puller (49-0636-145), remove wheel bearing inner race from hub. Remove wheel bearing outer race from knuckle using Handle (49-G030-797), Puller (49-F026-103) and Adapter (49-F027-005).
scientia non olet · About LEMON Manuals