Fuel Gauge Sending Unit
WARNING:
On vehicles with fuel-injected engine, relieve fuel pressure before servicing fuel system.
- Remove fuel gauge sending unit. Connect ohmmeter between the following wire terminals of fuel gauge sending unit connector:
- Yellow and Black
- Measure resistance with fuel gauge sending unit float at specified position. See FUEL GAUGE SENDING UNIT RESISTANCE . If resistance is not as specified, replace fuel gauge sending unit.
FUEL GAUGE SENDING UNIT RESISTANCE (1)
| Float Position | Ohms | ||
|---|---|---|---|
| Fully Raised | 2.4-3.6 | ||
| Three-Quarters | 15.2-16.4 | ||
| Mid-Range | 31.8-33.2 | ||
| One-Quarter | 62.7-65.7 | ||
| Fully Lowered | 107.5-112.5 | ||
|
|||