LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> MX-3 Base, Automatic >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Wheel Bearing >> Removal

Wheel Bearing: Removal

  1. Raise vehicle, and support using safety stands. Remove wheel assembly. Remove grease cap and lock nut. On models with disc brakes, disconnect brake line from strut assembly (as necessary). On all models, disconnect parking brake cable from rear brake assembly.
  2. Remove caliper assembly, and wire aside. Disconnect ABS speed sensor (if equipped). Remove brake drum or rotor. Remove ABS speed sensor rotor from hub (if equipped). Wheel bearing is an integral component of hub assembly. Replace hub assembly as necessary.
scientia non olet · About LEMON Manuals