AIR BAG Warning Light Flashes 5 Or 9 Times
- Cancel radio anti-theft function. See CANCELING & ACTIVATING RADIO ANTI-THEFT
under DISABLING & ACTIVATING AIR BAG SYSTEM. Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM
.
- Disconnect all 3 D-sensor connectors. Using a DVOM, check resistance between D-sensor connector (sensor side) terminals "A" and "B" of each sensor. See Fig 1
. If resistance is approximately 1.2 k-ohms, go to next step. If resistance is not approximately 1.2 k-ohms, replace faulty D-sensor. Perform TESTING - SYSTEM OPERATION CHECK
.
- Reconnect all 3 D-sensor connectors. With Short Circuit Connectors (49-H066-004) connected to diagnostic module connectors, using a DVOM, check for continuity between diagnostic module connector terminals 1H and 1M. See Figure
. If resistance is approximately 1.2 k-ohms, go to next step. If resistance is not approximately 1.2 k-ohms, replace wiring harness. Perform TESTING - SYSTEM OPERATION CHECK
..
- Check resistance between diagnostic module connector terminal 1G and 1O. See Figure
. If resistance is approximately 1.2 k-ohms, go to next step. If resistance is not approximately 1.2 k-ohms, replace wiring harness. Perform TESTING - SYSTEM OPERATION CHECK
.
- Check resistance between diagnostic module connector terminal 2H and 2F. See Figure
. If resistance is approximately 1.2 k-ohms, replace diagnostic module. Perform TESTING - SYSTEM OPERATION CHECK
. If resistance is not approximately 1.2 k-ohms, replace wiring harness. Perform TESTING - SYSTEM OPERATION CHECK
.
Courtesy of MAZDA MOTORS CORP.