LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> MX-3 Base, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Servicing >> NIPPONDENSO 10-Cylinder >> Clutch Coil & Bearing >> Removal

Clutch Coil & Bearing: Removal

  1. Hold clutch plate stationary and remove shaft bolt (or nut). Remove clutch plate using puller.
  2. Remove shim(s) from shaft and snap ring. Tap pulley off shaft with plastic hammer. If pulley cannot be removed by hand, use a puller.
  3. Remove snap ring, bearing, and seal (if equipped) from pulley. Remove screw for clutch coil lead. Remove snap ring and clutch coil.
scientia non olet · About LEMON Manuals