Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the MX-5 Miata Base, Automatic, NA4AEL, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,w/Rear Disc Brakes | 1.8 | B | ||
| Front | 1.0 | B | ||
| Rear,w/Disc Brakes | 1.0 | B | ||
| Combination Procedure: CALIPER: Overhaul: | ||||
| One,w/ABS | Includes: Bleed Brakes. | 0.9 | B | |
| One,w/o ABS | Includes: Bleed Brakes. | 0.5 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One,w/ABS | Includes: Bleed Brakes. | 0.7 | B | |
| One,w/o ABS | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| 0.6 | B | |||
| Combination Procedure: WHEEL BEARING: Repack: | ||||
| RWD, Front,Both Sides | 0.8 | B | ||
| Combination Procedure: WHEEL SEAL: Replace: | ||||
| RWD, Rear,Each Side | 0.4 | B | ||