Removal & Installation (MX-6 & 626)
- Raise and support rear of vehicle. Remove rear wheel assemblies. Release parking brake and disconnect parking brake cable from caliper. Remove upper guide bolt from caliper. Rotate caliper downward and secure with rope. Remove "V" springs. Remove pads and shims. Replace pad if lining thickness is less than .04" (1.0 mm).
- To install, turn caliper piston clockwise using Disc Brake Piston Wrench (49-FA18-602) to retract caliper piston. Ensure groove in piston aligns with alignment pin on back of inner pad. To complete installation, reverse removal procedure.