LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1992 >> MX-6 DX, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Brake Shoes & Wheel Cylinders >> Removal (B2200 & B2600i 2WD)

Removal (B2200 & B2600i 2WD)

  1. Raise and support vehicle. Remove rear wheel assemblies. Remove brake drum. Machine or replace drum as necessary if inner diameter is not as specified. See DRUM BRAKE SPECIFICATIONS  .
  2. Release parking brake and disconnect parking brake cable. Remove return springs and brake shoe spring. Remove brake shoe pin. See Figure . Remove brake shoes. Minimum brake shoe lining thickness is .04" (1 mm).
  3. Remove adjuster, operating lever, pawl lever return spring, and pawl lever. Using Flare Nut Wrench (49-0259-770B), disconnect brake line from wheel cylinder. Remove wheel cylinder.
scientia non olet · About LEMON Manuals