LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1992 >> MX-6 DX, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Brake Rotor >> Removal & Installation (929)

Removal & Installation (929)

  1. Raise and support vehicle. Remove rear wheel assemblies. Remove rear brake caliper with brake hose connected. Support caliper using rope. Remove ABS wheel speed sensor. Remove lock nut and washer. Separate drive shaft from rotor and hub assembly. Remove rotor.
  2. Machine rotor if lateral runout exceeds specification. Replace rotor if measured thickness is less than specified minimum thickness. See DISC BRAKE SPECIFICATIONS  .
  3. To install, reverse removal procedure. Tighten lock nut to 174-231 ft. lbs. (235-314 N.m). Check end play. If end play exceeds .004" (.10 mm), replace wheel bearings.
scientia non olet · About LEMON Manuals