LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1992 >> MX-6 DX, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Brake Rotor >> Removal & Installation (Navajo 2WD)

Removal & Installation (Navajo 2WD)

  1. Raise vehicle and support using safety stands. Remove front wheel assemblies and caliper. See FRONT DISC BRAKE PADS  . Remove grease cap, cotter pin, retainer, adjusting nut, washer, and outer bearing. Carefully remove hub and rotor assembly. Remove inner bearing and seal.
  2. To install, reverse removal procedure. Adjust front wheel bearings. While rotating rotor, tighten adjusting nut to 17-25 ft. lbs. (23-34 N.m) to seat bearings. Back off adjusting nut 1/2 turn. Tighten adjusting nut to 18-20 INCH lbs. (2.0-2.3 N.m). Install bearing retainer and new cotter pin.
scientia non olet · About LEMON Manuals