Removal (Navajo 4WD With Manual Locking Hubs)

1. Raise vehicle and support using safety stands. Remove front wheel assemblies and caliper. See FRONT DISC BRAKE PADS  . Remove retainer washers from lug nut studs. Remove manual locking hub assembly from spindle.
2. Remove snap ring from end of spindle shaft. Remove axle spacer. See Fig 1 . Using Lock Nut Wrench (49-UN01-042), remove outer wheel bearing lock nut. Remove lock washer. Using Lock Nut Wrench (49-UN01-042), remove inner wheel bearing lock nut. Remove outer wheel bearing, cup and rotor.

Fig 1: Removing Front Rotor (Navajo With Manual Locking Hubs)

Courtesy of FORD MOTOR CO.