LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1991 >> 626 LE, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Disc Brake Pads >> Removal & Installation (MX-6 & 626)

Removal & Installation (MX-6 & 626)

  1. Raise and support rear of vehicle. Remove wheel. Release parking brake and disconnect parking brake cable from caliper. Remove upper guide bolt from caliper. Rotate caliper downward and secure with rope. Remove "V" springs. Remove pads and shims.
  2. To install, turn caliper piston clockwise using Disc Brake Piston Wrench (49-FA18-602) to retract caliper piston. Ensure groove in piston aligns with alignment pin on back of inner pad. Replace pad if lining thickness is less than .04" (1.0 mm). To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals