LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1991 >> 626 LE, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Axle Bearing & Oil Seal >> Installation

Rear Axle Bearing & Oil Seal: Installation

  1. Install oil seal in axle housing. Install bearing inner race. Install and position oil seal flush with end of axle casing. Apply multipurpose grease to oil seal lip. Install spacer with concave side facing backing plate.
  2. Press axle bearing onto axle shaft. Using wrench, install and tighten lock nut to 145-217 ft. lbs. (197-295 N.m). Install axle shaft assembly. Install backing plate. Reconnect brake line and parking brake cable. Install brake drum and wheel. Bleed brake system.
scientia non olet · About LEMON Manuals