Removal (Navajo 4WD With Manual Locking Hubs)

1. Raise and support vehicle. Remove wheel assembly and caliper. See FRONT DISC BRAKE PADS  under REMOVAL & INSTALLATION. Remove retainer washers from lug nut studs. Remove manual locking hub housing from spindle.
2. Remove snap ring from end of spindle shaft. Remove axle spacer. See Fig 1 . Using Lock Nut Wrench (T86T-1197-A), remove outer wheel bearing lock-nut. Remove lock washer. Using Lock Nut Wrench (T86T-1197-A), remove inner wheel bearing lock nut, outer wheel bearing and rotor.

Fig 1: Removing Front Rotor (Navajo with Manual Locking Hubs)

Courtesy of FORD MOTOR CO.