LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1991 >> 626 LE, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Brake Rotor >> Removal & Installation (Navajo 2WD)

Removal & Installation (Navajo 2WD)

  1. Raise vehicle, and support using safety stands. Remove wheel and caliper assemblies. Remove dust cap, cotter pin, nut, washer and outer bearing. Carefully remove hub and rotor assembly. Remove inner bearing and seal.
  2. To install, reverse removal procedure. Adjust front wheel bearings. While rotating rotor, tighten adjusting nut to 17-25 ft. lbs. (23-34 N.m). Back off adjusting nut 120-180 degrees. Install bearing retainer and new cotter pin.
scientia non olet · About LEMON Manuals