LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1991 >> 626 LE, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Brake Rotor >> Removal & Installation (B2200 & B2600i 2WD)

Removal & Installation (B2200 & B2600i 2WD)

  1. With caliper assembly removed, remove wheel hub grease cap, cotter pin, lock plate and ring adjusting lock nut. Remove thrust washer and outer bearing from hub. Slide hub and rotor assembly from spindle.
  2. Mark rotor-to-hub position. Separate rotor from hub. Machine rotor if lateral runout exceeds specification. Replace rotor if measured thickness is less than specified minimum thickness. See DISC BRAKE SPECIFICATIONS  at end of article.
  3. To install, reverse removal procedure and evenly tighten rotor-to-hub bolts. Adjust wheel bearings. Removal & Installation (B2600i 4WD) 1) Remove front caliper. Set hub to FREE position. Remove hub bolts. Remove hub as an assembly. Install 2 bolts and nuts to retain hub assembly together. Remove snap ring and spacer.
  4. Remove set bolt and plate. Remove nut. Remove rotor and hub assembly. Mark rotor-to-hub position. Remove rotor from hub. Machine rotor if lateral runout exceeds specification. Replace rotor if measured thickness is less than specified minimum thickness. See DISC BRAKE SPECIFICATIONS  at end of article. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals