LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1991 >> 626 LE, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Brake Rotor >> Removal & Installation (929)

Removal & Installation (929)

  1. Raise and support front of vehicle. Remove wheel. Remove caliper with brake hose connected. Support caliper with rope. Remove hub cap, wheel bearing lock nut and washer. Remove hub and rotor assembly.
  2. Machine rotor if lateral runout exceeds specification. Replace rotor if measured thickness is less than specified minimum thickness. See DISC BRAKE SPECIFICATIONS  at end of article.
  3. To install, reverse removal procedure. Replace wheel bearing lock nut, and tighten to 72-130 ft. lbs. (98-177 N.m). Check hub end play. If end play exceeds .002" (.05 mm), replace bearing. If end play is within specification, stake lock nut at groove in axle shaft.
scientia non olet · About LEMON Manuals