Removal & Installation
- Raise and support rear of vehicle. On all models except 929, release parking brake and disconnect parking brake cable from caliper. On all models, disconnect brake hose from caliper.
- On Miata, Protege and 323, remove manual adjustment gear concealment plug from caliper. See Figure . Insert an appropriate size Allen wrench through hole and turn manual adjustment gear counterclockwise to retract caliper piston.
- On all models, remove lower guide bolt from caliper. Rotate caliper upward. Pull caliper toward center of vehicle to slide it off of caliper mount. To install, reverse removal procedure. Bleed hydraulic system.