LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> RX-7 Turbo >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Basic Testing >> Ignition Checks (Except RX7) >> Pick-Up Coil/IGNITOR (B2200, B2600I, MPV, MX-6 Non-Turbo & 626 Non-TUBBO)

Pick-Up Coil/IGNITOR (B2200, B2600I, MPV, MX-6 Non-Turbo & 626 Non-TUBBO)

  1. Disconnect pick-up coil from distributor. Using an ohmmeter, measure resistance between 2 inner terminals on pick-up coil. Replace pick-up coil if resistance is not as specified in DISTRIBUTOR PICK-UP COIL RESISTANCE  table.
  2. Ensure ignition coil has battery voltage. If ignition coil resistance and pick-up coil test okay, check for spark. If spark is still not available, go to TESTS W/CODES article.
DISTRIBUTOR PICK-UP COIL RESISTANCE

Application Ohms
B2200, B2600i & MPV 900-1200
MX-6 Non-Turbo, 626 Non-Turbo 900-1200
scientia non olet · About LEMON Manuals