LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> RX-7 Base, Automatic >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Wheel Bearing >> Removal

Wheel Bearing: Removal

  1. Raise and support vehicle. Remove wheel assembly. Remove drive axle lock nut. Remove brake caliper assembly and tie aside. Remove screws and remove rotor. Disconnect ABS speed sensor. Remove knuckle assembly from trailing arm.
  2. Loosen dust cover. Using a press, Installer (49 F026 102) and Puller (49 F026 103), remove hub from knuckle. Remove snap ring from knuckle. Using a press, installer and Puller (49 0636 145), remove wheel bearing inner race from hub. Remove wheel bearing outer race from knuckle using a press and Adapter (49 F027 007).
scientia non olet · About LEMON Manuals