LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> RX-7 Base, Automatic >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front >> Removal & Installation >> Wheel Bearing >> Removal (MX-6 & 626)

Removal (MX-6 & 626)

  1. Raise and support vehicle. Remove wheel assembly. Disconnect tie rod end from steering knuckle. Disconnect stabilizer bar from lower control arm. Remove axle lock nut.
  2. Disconnect brake line from strut assembly. Remove and wire aside brake caliper. Remove wheel speed sensor. Remove bolt attaching ball joint to steering knuckle. Remove bolts attaching steering knuckle to strut assembly. Remove steering knuckle.
  3. Remove wheel hub from knuckle using Puller Set (49-G033-1A1). Remove snap ring. Remove wheel bearing from steering knuckle using Remover (49-G033-106).
scientia non olet · About LEMON Manuals