LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> RX-7 Base, Automatic >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front >> Removal & Installation >> Wheel Bearing >> Removal (MPV 4WD)

Removal (MPV 4WD)

  1. Raise and support vehicle. Remove wheel assembly. Remove axle lock nut. Remove cotter pin, and disconnect tie rod from steering knuckle. Remove and wire aside brake caliper.
  2. Separate lower control arm from ball joint. Remove bolt attaching ball joint to steering knuckle. Remove bolts retaining steering knuckle to strut assembly. Separate hub and knuckle from drive shaft. Remove wheel hub and rotor from knuckle. Remove bearings and oil seals.
scientia non olet · About LEMON Manuals