Removal & Installation (MX-6 & 626 2-Wheel Steering)
- Disconnect negative battery cable and power steering pressure switch connectors. Raise and support front of vehicle. Remove front wheels.
- Remove cotter pins and castle nuts from tie rod ends. Remove tie rods from steering knuckles with suitable puller. Remove steering column intermediate shaft-to-steering gear pinion shaft bolt.
- Remove pressure and return hose connections from steering gear. Remove mud flap on driver's side. Remove steering gear mounting bolts. Remove steering gear through wheelwell on driver's side.
- To install, reverse removal procedure. Fill and bleed system. Tighten bolts to specification. See TORQUE SPECIFICATIONS table at end of article.