Pedal Height & Stoplight Switch
- Released pedal height is measured from carpet surface, on vertical portion of firewall, to pedal pad center. Disconnect stoplight switch electrical connector. Loosen lock nut on stoplight switch. Move switch away from pedal. Loosen push rod lock nut. Turn rod until correct pedal height is obtained. See PEDAL RELEASED in BRAKE PEDAL HEIGHT SPECIFICATIONS
.
- Adjust pedal free play. See PEDAL FREE PLAY
under ADJUSTMENTS. Tighten push rod lock nut. Rotate stoplight switch until it contacts pedal, then rotate an additional 1/2 turn. Tighten stoplight switch lock nut. Reconnect stoplight switch electrical connector.
- Applied pedal height is measured from angled portion of firewall (without carpet) to pedal pad center. Start engine. On B2200, B2600i and MPV, depress brake pedal with 33 lbs. (15 kg) pressure. On all other models, depress brake pedal with 132 lbs. (60 kg) pressure.
- On all models, measure applied pedal height. If distance is not as specified, check brake adjustment or air in system. See PEDAL APPLIED in BRAKE PEDAL HEIGHT SPECIFICATIONS
.
BRAKE PEDAL HEIGHT SPECIFICATIONS
| Application |
In. (mm) |
| Pedal Released |
| B2200 & B2600i |
7.1-7.3 (180-185) |
| Miata, MX-6, 626 & 929 |
6.7-7.1 (171-181) |
| MPV |
7.5-7.9 (191-201) |
| Protege & 323 |
7.6-7.7 (193-196) |
| RX7 |
7.2-7.4 (184-189) |
| Pedal Applied |
| B2200 & B2600i |
4.1 (105) |
| Miata, MX-6, 626 & 929 |
3.7 (95) |
| MPV |
5.2 (133) |
| Protege & 323 |
2.8 (70) |
| RX7 |
3.9 (100) |