LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> MX-6 DX, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Master Cylinder >> Removal

Master Cylinder: Removal

  1. Disconnect fluid level sensor coupler (if equipped). Disconnect and plug hydraulic lines at master cylinder to prevent entry of dirt and loss of fluid.
  2. Remove nuts attaching master cylinder to firewall or power brake unit. Remove master cylinder from vehicle. On RX7, remove proportioning valve by-pass bolt.
scientia non olet · About LEMON Manuals