LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> MX-6 DX, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Disc Brake Rotor (Pickup 2WD) >> Removal & Installation (B2200 & B2600i 2WD)

Removal & Installation (B2200 & B2600i 2WD)

  1. With caliper assembly removed, remove wheel hub grease cap, cotter pin, lock plate and ring adjusting lock nut. Remove thrust washer and outer bearing from hub. Slide hub and rotor assembly from spindle.
  2. Mark rotor-to-hub position. Separate rotor from hub. Machine rotor if lateral runout exceeds specification. Replace rotor if measured thickness is less than specified minimum thickness. See DISC BRAKE SPECIFICATIONS  at end of article.
  3. To install, reverse removal procedure and evenly tighten rotor-to-hub bolts. Adjust wheel bearings.
scientia non olet · About LEMON Manuals