LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> MX-5 Miata Automatic >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Wheel Bearing >> Removal

Wheel Bearing: Removal

  1. Raise and support vehicle. Remove wheel assembly. Remove drive axle lock nut. Remove brake caliper assembly, and wire aside. Remove screws and rotor. Disconnect ABS speed sensor. Remove knuckle assembly from upper and lower arms.
  2. Using a press, Installer (49-G030-727) and Puller (49-F026-103), remove hub from knuckle. Remove snap ring from knuckle. Using a press, installer and Puller (49-0636-145), remove wheel bearing inner race from hub. Remove wheel bearing outer race from knuckle using a press and Adapter (49-F027-005).
scientia non olet · About LEMON Manuals