LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> MX-5 Miata Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Power Brake Unit >> Removal & Installation

Removal & Installation

  1. Remove master cylinder from power brake unit. See MASTER CYLINDER under REMOVAL & INSTALLATION  in this article. Disconnect vacuum line at power brake unit. From inside vehicle, remove cotter pin and clevis pin. Separate push rod from brake pedal.
  2. Remove power brake unit-to-firewall nuts. Remove power brake unit. To install, reverse removal procedure. Bleed hydraulic system.
scientia non olet · About LEMON Manuals