LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1990 >> 323 SE, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL >> Removal & Installation >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

Disconnect negative battery cable. Remove drive belts and crankshaft pulley. Remove water pump pulley, timing belt covers and timing belt. See TIMING BELT  under REMOVAL & INSTALLATION. Use Crankshaft Lock Tools (49-S120-710 and 49-B011-102) to lock crankshaft sprocket into position. See Figure. Remove crankshaft sprocket bolt. Remove crankshaft sprocket using steering wheel puller. DO NOT loose Woodruff key. Pry out seal.

scientia non olet · About LEMON Manuals