LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1989 >> MX-6 DX, Automatic >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension - Electronic >> Testing & Diagnosis >> Self-Diagnostic System >> Notes

Self-Diagnostic System: Notes

NOTE: Perform a thorough visual inspect of all components before entering self-diagnostics.

Turn ignition to "OFF" position. Set analog voltmeter to 15-volt scale. Connect positive lead of voltmeter to Blue/White wire terminal of 3-wire test connector located in left rear corner of engine compartment. Connect negative voltmeter lead to Black wire terminal. See Figure . Monitor 4.4-volt pulses of voltmeter needle under the following conditions. Each pulse pattern is separated by a 2-second pause.

NOTE: Turn ignition switch to "OFF" position between each condition test to reset control unit. Failure to do so will result in false diagnosis.
scientia non olet · About LEMON Manuals