LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1989 >> MX-6 DX, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Brake Shoes >> Installation

Rear Brake Shoes: Installation

  1. Apply brake grease to brake shoe contact areas on backing plate. When installing adjuster between shoes, insert a flat-tipped screwdriver between adjuster quadrant and meshing teeth on MX-6 and 626, or between quadrant and knurled pin on 323 2WD. See Figure .
  2. To fully retract adjuster, move quadrant until it touches backing plate. To complete assembly, reverse removal procedure. Adjust wheel bearings and stake lock nut.
Fig 1: Exploded View of Rear Brake Assembly
G58060Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals