LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1989 >> MX-6 DX, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Disc Brake Rotor >> Removal & Installation (929)

Removal & Installation (929)

  1. Raise and support front of vehicle. Remove wheels. Remove caliper and wire out of way. Remove hub cap. Remove hub nut. Remove hub and rotor assembly.
  2. To install, reverse removal procedure. Tighten hub nut to 72-130 ft. lbs. (98-177 N.m). Check hub end play at hub cap. If end play exceeds .002" (.05 mm), replace bearing.
scientia non olet · About LEMON Manuals