Combination Switch
Disconnect battery ground. Remove steering wheel. Remove column covers and snap ring at top of column (if equipped). Unplug wiring connectors. Loosen combination switch screw. Remove switch. To install, reverse removal procedure.
323 DASH CONNECTOR PIN CALLOUT
| Pin Number | Destination | |
|---|---|---|
| Connector "A" | ||
| a-1 | Dash Lights | |
| a-2 | Turn Signal (RH) | |
| a-3 | Blank | |
| a-4 | Light Switch (High Beam) | |
| a-5 | Blank | |
| a-6 | Turn Signal (LH) | |
| a-7 | Water Temperature Sensor | |
| a-8 | Dash Light Switch | |
| a-9 | Ground (Lights) | |
| a-10 | Ground (Gauges) | |
| a-11 | Rear Defroster Switch | |
| a-12 | Ground (For System W/O Tach.) | |
| Connector "B" | ||
| b-13 | Ignition | |
| b-14 | Stop Light Failure Switch | |
| b-15 | Fuel Tank Unit | |
| b-16 | Brake Fluid Level Sensor | |
| b-17 | Oil Pressure Switch | |
| b-18 | Fuel Tank Unit | |
| b-19 | Ignition | |
| b-20 | Ground | |
| b-21 | Ground | |
| b-22 | Cruise Control Unit | |
| b-23 | Oscillator | |
| b-24 | Battery (+) | |
| Connector "C" | ||
| c-25 | Seat Belt System (+) | |
| c-26 | Ignition Coil | |
| c-27 | Seat Belt (-) | |
| c-28 | Alternator | |
| c-29 | Washer Fluid Level Sensor | |
| c-30 | Blank | |