Pedal Height, Free Play & Stop Light Switch
- Pedal height, measured from firewall to pedal pad center, should be as shown in chart. On the GLC, remove cover under instrument panel. On the 626, remove the blower duct. Disconnect the electrical connector of the brake stop light switch.
- On GLC, loosen lock nut on light switch and move switch away from pedal. Loosen lock nut on operating rod and turn rod until correct pedal height is obtained. On other models, loosen lock nut on stop light switch and turn switch until correct pedal height is obtained. Tighten lock nut and connect electrical connector.
- Pedal free play should be .28-.35" (7-9 mm). On GLC, adjust light switch, tighten lock nut, and replace electrical connector. On other models, loosen lock nut on operating rod. Turn rod until correct free play is obtained, and tighten lock nut.
BRAKE PEDAL HEIGHT ADJUSTMENT
| Application | In. (mm) |
|---|---|
| 626 | 8.4-8.6 (214-219) |
| GLC | 8.4-8.6 (210-220) |